Ventilation Settings - resideo Honeywell T6 Pro Smart Guia Del Usuario

Ventilation settings

Depending on your thermostat model number
and how your system was configured, the
following ventilation settings may be available:
• Vent mode: Turns ventilation on and off.
– Auto: Ventilation will run as programmed
by the installer.
– On: Ventilation is always on.
– Off: Ventilation will remain off unless
turned on using the timer.
• Boost: Provides temporary ventilation (for
20-180 minutes) for situations such as strong
cooking smells or when you'd like a little more
fresh air.
• Lockout: Prevents ventilation from running
during the Sleep period.
To change your ventilation settings, follow the
steps below.
1 Touch Menu on the thermostat home screen.
2 Touch the or
VENTILATION, then touch Select.
3 Touch the or
MODE, BOOST or LOCKOUT, then touch
Select.
• Vent mode: Touch the
select AUTO, ON or OFF, then touch Done
to confirm.
• Boost: Touch
many minutes ventilation will run,
then touch Done to confirm. To cancel
temporary boost, go into the Boost menu
again, where you'll be asked if you want
to enter a new value in minutes. Touch
Yes to enter a new value, then touch the
button to set the value to 0. Touch
Done to confirm.
• Lockout: In the lockout menu, you'll be
prompted to confirm whether you want
to prevent ventilation from running
during the Sleep period. Touch Yes or No
to confirm.
arrows until you see
arrows to choose VENT
or arrows to
or to choose how
Done
20
Cancel
Back Select
Back Select
Back Select
Back Select