DeVilbiss FRC-650 Manual Del Usuario página 6

PAGE 6 SB-6-377
PROCEDURE FOR CHANGING tHE FRC-650 AUtOMAtIC DRAINS
Required tools: 7/8"
(22 mm) dia. wooden
dowel, long nose pliers,
a rubber mallet, and a
¾" wrench (not shown)
Place the bowl on the
tool bench and place
the wooden dowel on
the outlet of the drain
with the white ring.
Remove the retaining
nut of the float type drain
with a ¾" wrench.
Hold the "umbrella"
type automatic drain
restrainer with the
pliers and pull it out.
Hit the dowel with
the rubber hammer
until the coalescent
reservoir comes out.
Remove the body of
the float type drain.
Remove the "umbrella"
type automatic
drain restrainer.
Lift the bowl to get to the
coalescent reservoir and
the float of the second
automatic drain.
Replace necessary parts.
Remove the "umbrella"
type automatic drain
with the pliers
Inside the bowl you will see
the float type drain body.
Place the float type drain
in the smaller of the
two holes in the base of
the bowl. (Hole on the
right as shown here.)