DeVilbiss FRC-650 Manual Del Usuario página 7

PROCEDURE FOR CHANGING tHE FRC-650 AUtOMAtIC DRAINS (continued)
Screw on the float
type drain nut.
Place the wooden dowel in
the coalescent reservoir.
The white ring of the
reservoir should extend
approximately 1/16" (1.5
mm) outside the bowl.
Tighten the nut with
a ¾" wrench.
Turn the bowl over and
center the outlet of the
"umbrella" type drain.
Hold the "umbrella" type
drain with the pliers.
Put the coalescent
reservoir inside the bowl.
Put the bowl on a vise as
shown in the illustration.
Fit the "umbrella" type
drain into the O-ring
located in the fitting in the
bottom of the reservoir.
SB-6-377 Page 7
Check if the reservoir is
positioned correctly in the
guide lines of the bowl.
Hit the wooden dowel
with the rubber hammer
until the reservoir fits
tightly in the bowl
Check if the "umbrella"
type drain is correctly
inserted.