Selection Of Audio/Video Source; Recording An Audio Source - Aiwa AV-X100 Manual De Instrucciones

SELECTION OF AUDIO/VIDEO
SOURCE
L
[
['
1
1 Select the speaker system
SPEAKERS A and B buttons.
1
!
with the FRONT
Press one of the FRONT SPEAKERS buttons.
2 Select the program source.
Press one of the FUNCTION buttons or the TAPE MONITOR
button.
\ Record \ PHONO
I
I Television, etc.
\ AUX/TV
I
\ Compact disc I CD
I
Video (LD or MD) VIDEO 1, VIDEO 2 (LD/MD),
VIDEO 3
3
Start the selected program source.
4 Adjust the sound.
About the video signal to the monitor or TV
Selected ~lDEO signal
RECORDING AN AUDIO SOURCE
1
2
3
1
fi.
n
0 00000
TAPE MONITOR
Select the program source to be recorded.
Press one of the FUNCTION buttons.
Set the tape deck or MD recorder to the recording
mode.
Start the selected program source.
To monitor recorded sound during recording (when the
connected tape deck is a three-head system)
Press the TAPE MONITOR button. "TAPE ON" appears on the
display for four seconds, and then the source name selected in
step 1 comes back on. To cancel the tape monitor, press it again
so that "TAPE oFF" appears.
Any sound control except the BBE system has no effect on
recording (see page 7).
Recorded sound cannot be monitored if the connected tape
deck is not a three-head system.
The selected video signal output through the MONITOR VIDEO
OUT jack is indicated on the display.
9
ENGLISH