Before Operation; Setting The Clock - Aiwa AV-X100 Manual De Instrucciones

BEFORE OPERATION SETTING THE CLOCK
TAPE MONITOR
POWER I FUNCTION buttons
1,3,5
PHONES FRONf SPEAKERS A, B
To turn the unit on
Press one of the FUNCTION buttons (TUNER, PHONO, AUX/
TV, CD, VIDEO 1, VIDEO 2, VIDEO 3) or the TAPE MONITOR
button. When pressing the TUNER button, the previously tuned
station is received (Direct Play Function).
The POWER button is also available.
When turning the unit on:
- Turn the VOLUME control toward MIN. Otherwise, the
speakers may be damaged
- Operation is impossible for four seconds
To change a source name on the display
With the power on, press the POWER button while pressing the
AUX/TV or VIDEO 2 button.
Repeat the procedure to select one of the names shown below.
AUX or TV: For the AUX/TV button
VIDEO 2, LD or MD: For the VIDEO 2 button
To select the front speaker system
To use speaker system A: Press the FRONT SPEAKERS A
button.
To use speaker system B: Press the FRONT SPEAKERS B
button.
To use both speaker systems : Press both the buttons.
Press the button(s) again to set the speaker system(s) to off.
As the front speaker systems A and B are connected in series:
- The sound will be slightly decreased when using both speaker
systems
- No sound can be heard if the FRONT SPEAKERS A and B
buttons are set to on when only one speaker system is
connected
Using the headphones
Connect headphones to the PHONES jack with stereo standard
plug (06.3 mm, 1/4 inch).
Be sure to set the FRONT SPEAKERS A and B buttons to off.
m
When using the headphones, set the Dolby Pro Logic and DSP
system to off.
CLOCK
2,4
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1
2
3
4
5
Press the SET button.
The hour flashes.
Press the SET button to set the hour.
The hour stc)ps flashing and the minute starts flashing.
Press the
DOWNV or'UPA
button to designate
the minute.
Press the SET button to set the minute ancl
complete setting.
The minute stops flashing cm the display and the clock start:s
from 00 second.
To correct the current time
Press the POWEFI button to turn the unit off. Press the SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button on the remote control. The clock i:>
displayed for 4 seconds.
To switch to the
24-hour standard
Press the POWER button while pressing the UPA or DOWNIF
button.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase needs to be reset.
After use
Press the POWER button to turn off the unit. The display changes
to the clock.
ENGLISH 6