Installation Instructions; Tools Required - GE 16 Instrucción De Instalación

REVERSING
Installation instructions
THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before starting.
• Handle parts carefully to avoid scratching paint.
Set screws down by their related parts to avoid using them
in the wrong places.
Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the cabinet
until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side--if you ever want to change the
hinges back to the right side, follow these same instructions
and reverse all references to left and right.
TOOLS REQUIRED
Phillipsscrewdriver
Maskingtape
5/16" hex-head
socketdriver
T20or T25Torxdriver
(needed for somemodels)
Puttyknife or thin-blade
screwdriver
5/16" open-end
wrench
F_ REMOVE THE FREEZER DOOR
2.1 Tape the door shut with masking tape.
2.2With a 5/16" hex-head socket driver, remove the
screws that hold the top hinge to the cabinet.
2.3 Lift the hinge straight up to free the hinge pin from
the socket in the top of the door and set it aside,
along with its screws.
TopHinge
2.4 Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
2.5Set the door on a non-scratching surface with the
outside up.
m BEFORE YOU START
1.1 Unplug the refrigerator from its eleetriea II
outlet,
1.2Empty all door shelves, including the dairy
compartment.
CAUTION:
Do not let either door drop to the floor. To
do so could damage the door stop.
2.6Transfer the 2 screws from the opposite side of the
cabinet to the screw holes vacated by the top hinge
removal.
11