Wireless Connection: Ezlink Function; Wireless Connection: Wps Function - THOMSON DSC-523W Manual De Instrucciones

C - INSTALLATION

2.1. WIRELESS CONNECTION: EZLINK FUNCTION*

* Only available for cameras with UIDs that end in "ZZZ" (check under your camera). If the
end of your camera's UID is different, proceed to the wired connection step.
• Your camera is fitted with the EzLink function: if you have an Android or iOS smartphone or tablet, the
application can connect to the camera when it is shown which WiFi network to use.
• Important: To be configured for the EzLink function, your camera must use the default user name and
password. If necessary, reset your camera by pressing the "Reset" button under the camera for at least
10 seconds.
• Then connect your smartphone or tablet to the
WiFi network that your camera will use, then
launch the Thomview application.
Important note:
Your camera is not compatible with 5 GHz wireless
networks (802.11ac WiFi network). Do not connect
your smartphone or tablet to this type of network.
Click on then scan the QR code on the camera.
Once the code has been read, your smartphone or tablet asks you to choose between LAN and WiFi.
Select WiFi, press "Prêt(e)" (Ready), then enter the key for the WiFi network to which you are connected to
send it to the camera.

2.2. WIRELESS CONNECTION: WPS FUNCTION

If your box or router has a WPS (WiFi Protected Setup) function, you can use the WPS button on the back
of the camera for quick connection to your WiFi network. Refer to your modem/router/box user guide to
find out whether you have the WPS function and, if so, how to use it.
* Click on [ + ] icons, then scan the QR code on the camera. If your camera is properly connected to the
Internet, it will be automatically added.
Otherwise, add it using "WIRED CONNECTION" or "EzLink".
8
EN
MOTORISED 720P HD WIFI IP CAMERA
u . e i t y u r e c n s s o m o t h w . w w
OUT IN
Micro SD