To Check Safety Valve - Craftsman 919.195413 Manual De Instrucciones

CUSTOMER RESPONSiBiLiTiES
Before i Daily Every Every Every Every Yearly
each i or 8 40 100 160
use after hours i hours hours hours
each
use
Check Safety Valve •
Drain Tank
Oil Leaks
Check Pump Oil
Change Pump Oil
Unusual Noise and/
or Vibration
Air Filter o 1
Drive Belt-Condition
Motor Pulley/Flywheel
alignment
Air compressor
pump intake and
exhaust valves
Inspect air lines and *
fittings for leaks
Head Bolts - Check the torques of the head bolts after the first five hours of operation.
1- more frequent in dusty or humid conditions
_Risk of Unsafe
__ Operation. Unit
cycles automatically when power
is on. When servicing, you may
be exposed to voltage sources,
compressed air, or moving parts.
Before servicing unit unplug or
disconnect electrical supply to
the air compressor, bleed tank
of pressure, and allow the air
compressor to cool.
To ensure efficient operation and lon-
ger life of the air compressor, a routine
maintenance schedule should be pre-
pared and followed. The above routine
maintenance schedule is geared to an
air compressor in a normal working
environment operating on a daily basis.
If necessary, the schedule should be
modified to suit the conditions under
which your air compressor is used.
The modifications will depend upon
the hours of operation and the work-
ing environment. Compressors in an
extremely dirty and/or hostile environ-
ment will require a greater frequency of
all maintenance checks.
NOTE: See Operation section for the
location of controls.
TO CHECK SAFETY VALVE
E__ Risk of Bursting.
If the safety valve
does not work properly, over=
pressurization may occur, causing
air tank rupture or an explosion.
E__ Risk from Flying
__ Objects. Always
wear certified safety equipment:
ANSi Z87.1 eye protection (CAN/
CSA Z94.3) with side shields.
N000578 18-ENG