Before Each Start=Up - Craftsman 919.195413 Manual De Instrucciones

5. Move the Auto/Off switch t o"Auto"
position. The compressor will s tart.
6. Run thecompressor for20min-
utes. M ake sure thedrain valve
isopen and there isminimal air
pressure build-up i ntank.
7. After 2 0minutes, close thedrain
valve byturning c lockwise. The air
receiver will f illto"cut-out" pres-
sure andthemotor w ill stop.
The compressor isnow ready f oruse.
Before Each Start=Up
1. Setthe Auto/Off switch to"Off".
2. Pull r egulator knob out,turn
counterclockwise until i tstops.
Push knob into lockinplace.
3. Attach h ose andaccessories.
NOTE: The hose oraccessory will
require a quick connect plug ifthe
airoutlet i s
equipped with a quick
connect socket.
_Risk of unsafe
__ operation. Firmly
grasp air hose in hand when
installing or disconnecting to
prevent hose whip.
_Risk of unsafe
__ operation. Do not
use damaged or worn accessories.
Risk of Bursting.
Too much air
pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air
tools and accessories. The regulator
outlet pressure must never exceed
the maximum pressure rating.
Risk of unsafe
operation.
Compressed air from the unit may
contain water condensation and
oil mist. Do not spray unfiltered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the instructions for the air
tools and accessories.
Bow to Start
1. Set the Auto/Off switch to "Auto"
and allow tank pressure to build.
Motor will stop when tank pressure
reaches "cut-out" pressure.
2. Pull the regulator knob out and
turn clockwise to increase pres-
sure. When the desired pressure
is reached push knob in to lock in
place.
_lf any unusual
__ noise or vibration
is noticed, stop the compressor
immediately and have it checked by
a trained service technician.
The compressor is ready for use.
17- ENG N000578