LG LSM-C114M Manual Del Propietário página 9

Location and Operation of controls
12
6. VIDEO 1 TACT SWITCH
Set the switch to VIDEO 1 is set when camera jack is used.
7. VIDEO 2 TACT SWITCH
Set the switch to VIDEO 2 is set when camera jack is used.
8. S-VIDEO TACT SWITCH
Set the switch to S-VHS if the S-VIDEO jack is used.
9. UNDER SCAN
Press the button, select the desired display size for OVER SCAN and
UNDER SCAN.
10. POWER SWITCH
Press to turn the monitor ON. The POWER LAMP above the switch will
illuminate.
11. POWER LED LAMP
Power lamp indicates the power is on.
12. AC INLET
Use 100-240V AC, 50/60 Hz.
To prevent electrical shocks and fire hazards, do not use any other
power source.
13~16.VIDEO INPUT & OUTPUT CONNECTORS
These BNC connectors permit looping of a video signal in those installa-
tions where it is desirable to display the video signal on more than one
monitor. A standard 1.0 Vp-p video signal applied to the VIDEO INPUT
will also appear at the VIDEO OUTPUT. Use coaxial cables with BNC
type plugs for these connections.
17. S-VIDEO JACK
If the camera or other video source outputs an S-VIDEO signal, connect
it directly to this jack.
18~23.AUDIO INPUT & OUTPUT CONNECTORS
Connect an RCA cable between these jacks and the audio output jack
of a camera or VCR.
19
13 14 18 20
22
15 16 17 21 23
9