Step 6 Move The Refrigerator - Monogram ZWE23E Instrucciones De Instalación

Ocultar thumbs Ver también para ZWE23E:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 5 REMOVE THE FRESH
FOOD DOORS (CONT)
D. Disconnect the water line from the back of the unit
by pressing down on the dark grey collar while
pulling up on the water line.
Pull waterline through case conduit from the top to
free the line for door removal. The water line is more
than 4' long and may need to be taped to Door for
accessibility when reinstalling.
E. Using a 3/8" socket ratchet/
driver, remove the screws
securing the top hinge to the
cabinet, then lift the hinge
straight up to free the hinge
pin from the location in the top
of the door.
CAUTION
Lifting Hazard.
Single person lift could cause injury. Use assistance
when handling, moving or lifting the refrigerator
doors.
Installation Instructions
9
STEP 5 REMOVE THE FRESH
FOOD DOORS (CONT)
Note: for proper installation later, please follow the next
step carefully.
F. Fresh Food doors to be REMOVED and INSTALLED
opened at 90° with case front.
REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite door.
There are no wires or water lines on the opposite
side.
REMOVE CENTER HINGE (if necessary)
G.
Remove the 3/8 screws securing the center hinge to the
cabinet. Use T20 driver to remove outboard screw.
Remove
center screw

STEP 6 MOVE THE REFRIGERATOR

• Place a piece of the carton or soft cloth against
the side panel of the refrigerator to pad and protect
the stainless steel finish.
• Place the refrigerator on the handtruck with a side
against the truck only.
• Move the refrigerator indoors. Place refrigerator close
to the installation location.
Loosen Outer screws

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zwe23p

Tabla de contenido