Black+Decker BDCI202 Manual De Instrucciones página 50

Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
• Unit shuts off abruptly.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DeCKer help line at
1-800-544-6986.
AcceSSoRIeS
recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with this tool could
be hazardous.
the RBRc™ Seal
The rBrC™ (rechargeable Battery recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid
by BLACK+DeCKer . In some areas, it is illegal to place spent lithium-ion
batteries in the trash or municipal solid waste stream and the rBrC program
provides an environmentally conscious alternative.
rBrC in cooperation with BLACK+DeCKer and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by returning
the tool to an authorized BLACK+DeCKer service center for recycling. You may also
contact your local recycling center for information on where to drop off the spent battery,
or call 1-800-8-BAtteRy.
This Class B digital apparatus complies with Canadian ICeS-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
tRoUBleSHootING
Possible cause
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( to
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
10
Possible Solution
• Check battery pack
installation.
• Check battery pack charging
requirements.
charger until green LeD
appears.
• Plug charger into a working
outlet. refer to "Important
Charging Notes" for more
details.
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4.5°C) or below
105 degrees F (+40.5°C).
• Allow battery pack to cool
down.
• Place on charger and
allow to charge.