Junghans J644.96 Manual De Instrucciones página 17

Alarm chronograph controls and functions
7
1
MIN
45 15
30
12H
6
19
9 3
6
1/20S
.8 .2
.6 .4
11 OFF
A
SEC
B
10
3
Setting the time
Pull the winder into position C. That stops the watch movement. To
set your watch accurately to the second, it is best to stop the move-
ment as the second hand is passing the figure 60. You can now posi-
tion the minute hand precisely in line with the relevant minute
marker and set the desired time. Press the winder back into position
A to start the second hand.
32
2 1 Hour hand
2 Minute hand
12
3 Chronograph hand
4
4 Date display
5
5 Winder
6 Hours counter
7 Minutes counter
A B C
8 1/20 seconds counter
9 Alarm hand
13
10 Alarm on/off
indicator
9
11 Alarm winder
8
12 Start/stop button
13 Reset button
Setting the date
Pull the winder into position B. You can now set the date by turning
it to the left. Do not make any changes to the date between 8pm
and 3am, as the date is automatically advanced by the movement
during this period and you could damage the date advance mecha-
nism.
If the month has less than 31 days, you have to set the date manual-
ly to the first day of the following month.
Operating the chronograph
Start timing
You start the chronograph by pressing the start/stop button (12). The
1/20 second hand stops automatically when it reaches the '0' sec-
onds position, 30 seconds after the chronograph has been started.
At the end of the timing process, the second hand shows the
elapsed time.
Stop timing
You stop the chronograph by pressing the start/stop button (12)
again.
33