Elkay DSPOUWCS1 Manual De Instalación, Cuidado Y Uso página 10

Installation
For correct and safe installation, please read these instructions completely.
DANGER
• All installation work must be performed by an authorized service personnel.
• Disconnect electrical supply serving the installation area to reduce risk of electrocution.
• Unit not suitable for installations where water jets could be used.
WARNING
• Warranty is void if installation is not made in accordance with current manufacturer's instructions.
To install your water dispenser onto the wall, read all the steps below.
Step 1:
Place the mounting bracket against the wall and mark the 3 pivot points.
Drill 3 holes at the pivot points and insert the 3 anchors into the holes.
Fix the mounting bracket onto the wall using the 3 screws, as illustrated
in Figure 1. Make sure that the 2 hooks on the mounting bracket are
levered.
Step 2:
Attach the PE tubing to the water inlet of the dispenser and then mount
the dispenser to the 2 hooks on the mounting bracket in the sequence
as shown in Figure 2.
Step 3:
Connect the water inlet to the drinking water source, such as a water
filtration system, and turn on the drinking water supply. Connect the
dispenser to the power supply and turn on the power ONLY after turning
on the water supply to feed water into the dispenser. See Figure 3.
1000003421 (Rev. A - 03/16) Page 10
Figure 2
Figure 3