Tabla de contenido
Publicidad
2
Figure 5
Page - 18 -
1
2
CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher
HOW TO OPERATE THE MACHINE
WARNING: Machines can ignite flam-
mable materials and vapors.
Do not use with or near flam-
mables, such as:
grain dust, solvents and
thinners.
CAUTION:
Allowing the machine to run
without moving forward or
backward can cause serious
damage to the floor surface.
Make sure the machine is al-
ways moving when the pad is
rotating.
NOTE: You must have training in the operation of
this machine before you use it.
How To Start/Stop The Machine
WARNING: Never start a burnisher when
the handle is in the vertical
position.
The switch to start and stop the machine is activated
by the interlock (1) and the levers (2) under the handle
grips. See Figure 5.
To start the machine, follow this procedure:
1. Depress the handle release lever with your foot and
lower the handle.
NOTE: Make sure you hold the handle with both
hands.
2. Continue to move the handle to the rear until the
handle is in the operating position. The handle
moves freely up and down when it is in the
operating position.
3. Push the interlock switch (1), and apply pressure to
one of the levers (2). See Figure 5.
4. Push the machine forward on the floor. Move the
machine slow on dirty surfaces. Move the ma-
chine faster on cleaner surfaces.
The Circuit Breaker
A circuit breaker is used to protect the motor. If the motor
draws high current, the circuit breaker will stop the motor.
The circuit breaker reset button is near the pad pressure
meter. Push the button to reset the circuit breaker. If the
motor continues to stop, consult an authorized service
person.
gasoline,
Publicidad
Tabla de contenido
