Alto CLARKE US 1500 Libro De Instrucciones página 20

Figure 6
Page - 20 -
How to Put the Machine in Storage
WARNING:
To put the machine in storage, follow this procedure:
1. Put the handle in the vertical position.
2. Disconnect the power cord from the electrical outlet.
3. Pull the handle to the floor so that the pad is exposed.
4. Check the pad.
5. Remove or replace the pad if worn or dirty.
6. Put the machine in the verticle position.
7. Wind the power cord around the motor.
8. Depress the handle release lever and fold the handle
horizontally across the power cord and motor.
9. Tilt the machine on its back so that it sits on its rear
wheels and rear bumper pads. See figure 6.
NOTE: Do not store the machine resting on the
pad driver, the pad driver will warp and cause
vibration.
Inspection and Repairs
Take the machine to the nearest Clarke Technology
authorized repair location once a year for the maintenance
inspections.
To make any repairs, take the machine to the nearest
Clarke Technology authorized repair location.
WARNING: Maintenance and repairs
CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher
Always remove the electrical
plug from the electrical outlet
before installing or changing the
bag.
must be done by authorized
personnel only