Remote Control Management; Memory Test; Procedure For Total Deletion Of The Memory; Procedure For Self-Teaching Of The Fi Rst Remote Control - Aprimatic UNICO RR-SE Manual De Instrucciones

5. REMOTE CONTROL MANAGEMENT

Power
OFF
supply
Buzzer
memory is available for the addition of extra remote controls.
When the receiver is turned ON, after a brief pause during which
the memory is scanned, the buzzer emits a certain number of
beeps (from 1 to 10) to indicate the percentage of the memory
which is free: each beep corresponds to approximately 10%
free memory (10 beep = 100% free memory).

5.2 Procedure for total deletion of the memory

1. Power down the receiver.
2. Power up the receiver again, holding down the delete button
(see fi g.1) Release the button when both the LED and the
buzzer have gone OFF.
3. You must now wait until the deletion operation is completed.
When it is completed, the unit will run the memory test.
Power supply
ON
(delete) button
Buzzer
5.3 Procedure for self-teaching of the fi rst remote control
Button 1
Aprimatic
TR2 units, 4 buttons for TR4 units) until both the LED and the
buzzer come ON (continuous beeping) to inform you that the
self-teaching stage is running.
4. Now press any key on the transmitter.
5. The LED and the buzzer go OFF briefl y and then come back
ON, confi rming the self-teaching of the remote control within
the receiver memory.

5.4 Procedure for self-teaching of other remote controls

When the self-teaching of the fi rst remote control is completed,
while the signal is still ON, you can add other remote controls
by repeating steps 3 and 4.
Afterwards, you can start the remote control saving procedure
again by pressing, at the same time, all the buttons on a TX
which has already been saved: the buzzer will sound and you
can now add extra remote controls by repeating steps 3 and 4.
INFORMATION:
• The procedure for self-teaching of the fi rst remote control,
as described above, is only possible if the RX memory is
completely empty.
• To quit the saving procedure, simply press the the delete
button.
ON
Memory free
signal
OFF ON
OFF ON
OFF ON
Deletion
command
Button 2
Button 1
Aprimatic
Button 3

5.1 Memory test

All the information about the
remote controls is saved in the
removable memory module:
every time the receiver is turned
ON, a test is run automatically
to establish which part of the
OFF
OFF
Deletion
phase
1. Power up the receiver.
2. Make sure that the
memory is completely free
Button 2
(10 consecutive beeps); if
Button 4
not, delete the memory.
3. Press all the buttons
on the fi rst remote control
you want to add at the
same time (2 buttons for
15
Memory free
signal