Installation Procedure; Apply Power To The Processor - Rockwell Automation Allen-Bradley SLC 5/03 Instrucciones De Instalación

Ocultar thumbs Ver también para Allen-Bradley SLC 5/03:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
All manuals and user guides at all-guides.com

Installation Procedure

Install the Processor
Make sure system power is off; then insert the processor into slot 0 of the 1746
chassis.
Important:
The SLC 500 modular processors must be inserted into the left slot
(slot 0), as shown below. In addition, remove the protective wrap after
installing the processor.

Apply Power to the Processor

1. Energize the chassis power supply.
2. Check the chassis power supply and processor LEDs. The power LED on the
power supply should be on and the fault LED on the processor should be
flashing. See the figure on page 8 for location of the power supply and processor
LEDs.
SLC 5/03™, SLC 5/04™, and SLC 5/05™ Modular Processors
Power
Supply
Card Guide
Protective Wrap
Processor Release
Publication 1747-IN009A-ML-P
7

Publicidad

Tabla de contenido
loading

Tabla de contenido