General Maintenance - Weber Summit 56070 Manual De Instalación

PROBLEM
Side Burner does not light.
Flame is low in "HI" position
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
®
site. Log onto www.weber.com .
IGNITER
If the Ignition system fails to ignite the side burner, light the burner with a match.
• Check that both ignition wires are attached properly.
• You should hear the igniter sparking.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site.
Log onto www.weber.com ® .
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be in the
"OFF" position.
Make sure ignition wires(1) are connected between the igniter and electrodes.
Make sure grounding wire(2) is connected between the igniter and grounding clips on the
burner cups.
2
WWW.WEBER.COM
®
SIDE BURNER TROUBLESHOOTING
CHECK
Is gas supply off?
Is the fuel hose bent or kinked?
Does burner light with a match?

GENERAL MAINTENANCE

Spark should be a white/blue color, not yellow.
1)
2)
3)
1
1
Turn supply on.
Straighten hose.
If match lights burner, check igniter (see below).
Igniter Wires
Ground wire
Burner
3
15
CURE