Weber Summit 56070 Manual De Instalación página 7

LOCATING YOUR BUILT-IN SIDE BURNER APPLIANCE
When determining a suitable location for your Built-In Side Burner installation, give
attention to concerns such as exposure to wind, proximity to traffic paths, and keeping
any gas supply lines as short as possible. Never locate the Summit
in a garage, breezeway, shed, under overhang, or other enclosed area. Locate the Side
Burner and structure so there is enough room to safely evacuate the area in case of a
fire.
CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES
WARNING: Clearance from the outside walls of the sides
and back of the Built-In Side Burner must be a minimum
of 24 inches (61 cm) from any combustible surface. Refer
to "Installation/Gas Instructions" section before starting
installation.
The structure, "island" counter tops and adjacent work areas
for the Built-In Side Burner installation must be built from
noncombustible materials only. Incorrect installation may
result in a fire, which can cause serious bodily injury or
death, and cause damage to property.
NOTE: If you have questions on what materials are considered noncombustible, contact
you local building supplier or fire department.
BUILT-IN STRUCTURE CUTOUT DIMENSIONS
All dimensions are to finished surfaces.
C
B
A
WARNING: All counter top finished surfaces must be
constructed of a noncombustible material.
WWW.WEBER.COM
®
® Built-In Side Burner
DANGER
INSTALLATION
A B
A
B
C
Note: For a countertop treatment: Recommended 3/4" (19 mm) overhang.
1
Notch front edge for frame to fully slide in.
Cut out Dimensions
A
B
C
B
C
1
SIDE BURNER LOCATION
Any Surface
24" (61 cm) From Any Combustible Surface
Side Burner
SIDE BURNER
12 3/8" (31.4 cm) + 1/8" - 1/8" (3.18mm)
7 7/8" (20 cm)
27" (68.6 cm) + 1/8" - 1/8" (3.18mm)
7
B A
Tolerances
-