Wall Mounting Instructions - Dimplex V1525BT Manual Del Propietário

Fireplace Installation
from the fireplace.
3. Please glass assembly with
it's back facing down on a flat
surface.

Wall Mounting Instructions

1. Leave the trim uninstalled
until step 9.
2. select a location for the
fireplace, preferably above
an electrical outlet and there
must be at least one wall
stud behind for the fireplace
to mount onto. The bottom
of the unit must be a mini-
mum of 4" space above the
floor (mounting holes 29.5"
minimum above the floor).
Access to the electrical outlet
must be maintained. Ensure
the installation meets the
national and state/provincial
electrical codes.
!
NOTE:
It is recommended
that the bottom of the unit not be
mounted higher than 48" from the
ground to maintain an optimized
viewing angle of the flame.
CAUTION: The fireplace must
be mounted at two points, one of
which must be on a wall stud.
WARNINg: High temperatures
may be generated under certain
8
All manuals and user guides at all-guides.com
abnormal conditions. Do not
partially or fully cover or obstruct
the front of this heater. Bottom
of unit must be a minimum of 4"
above floor or any surface such
as a tabletop to ensure adequate
ventilation through air intake
located at the bottom of the
fireplace. (Figure 3)
3. With a wall stud finder, locate
the center of the wall stud,
drive a wood screw into stud
and leave approximately 1/8"
exposed threads for the fire-
place to hang on.
4. The second mounting point
should be picked such that it
Figure 2
www.dimplex.com