Replacing License Plate Lamp Bulbs; Replacing High-Mount Brake Lamp Bulbs; Replacing Foglamp Bulbs - Mercury Mariner 2006 Manual De Instrucciones

Lights

Replacing license plate lamp bulbs

1. Make sure the headlamp switch is
in the OFF position and then pry
the license plate lamp assembly
(located above the license plate)
from the liftgate.
2. Remove bulb socket from lamp
assembly by turning
counterclockwise.
3. Pull the bulb out from the socket
and push in the new bulb.
4. Install the bulb socket in lamp assembly turning it clockwise.
5. To install, press the lamp assembly into liftgate.

Replacing high-mount brake lamp bulbs

To remove the lamp assembly:
1. Remove the two screws and move
the lamp assembly away from the
liftgate.
2. Remove the bulb holder from the
lamp assembly by depressing the
snaps.
3. Pull the bulb straight out of the
socket and push in the new bulb.
To complete installation, follow the
removal procedure in reverse order.

Replacing foglamp bulbs

For bulb replacement, see your authorized dealer.
42
2006 Mariner (mrn)
Owners Guide (post-2002-fmt)
USA (fus)