Mercury Mariner 2006 Manual De Instrucciones página 370

Driver Controls
4WD LOCKED TEMPORARILY (if equipped). Displayed when the
4X4 is temporarily locked. If the warning stays on or continues to come
on, contact your authorized dealer as soon as possible.
4WD DISABLED TEMPORARILY (if equipped). Displayed when the
4X4 is temporarily disabled. If the warning stays on or continues to come
on, contact your authorized dealer as soon as possible.
4WD AUTO RESTORED (if equipped). Displayed when the 4X4 is
restored to normal operations.
ENGINE OIL CHANGE SOON/ENGINE OIL CHANGE NOW.
Displayed when the engine oil life remaining is 5% or less. When oil life
left is between 5% and 0%, the ENGINE OIL CHANGE SOON message
will be displayed. When oil life left reaches 0%, the ENGINE OIL
CHANGE NOW message will be displayed.
An oil change is required whenever indicated by the message center.
USE ONLY RECOMMENDED ENGINE OILS.
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 12 months] perform the
following:
1. Select this function from the
INFO menu then press the SET
control to access the system check
function.
2. Press and release the SET control
to display "OIL CHNG XXX% HOLD
SET NEW".
3. Press and hold the SET control
for 2 seconds to display "OIL
CHANGE SET TO 100%".
INFO UNAVAIL. These messages indicate improper operation of the
vehicle network communication systems for the following vehicle
modules.
62
2006 Mariner (mrn)
Owners Guide (post-2002-fmt)
USA (fus)