Mercury Mariner 2006 Manual De Instrucciones página 415

• seat-mounted side airbags (if equipped). Refer to Seat-mounted side
airbag system later in this chapter
• Safety Canopy
system (if equipped). Refer to Safety Canopy
system later in this chapter.
• one or more impact and safing sensors.
• a readiness light and tone.
• diagnostic module.
• and the electrical wiring which connects the components.
• Front passenger sensing system. Refer to Front passenger sensing
system. later in this chapter.
• "Passenger airbag off" or "pass airbag off" indicator lamp. Refer to
Front passenger sensing system later in this chapter.
The RCM (restraints control module) monitors its own internal circuits
and the supplemental airbag electrical system wiring (including the
impact sensors, the system wiring, the airbag system readiness light, the
airbag back up power and the airbag ignitors).
Several air bag system components get hot after inflation. Do not
touch them after inflation.
If the airbag has deployed, the airbag will not function again
and must be replaced immediately. If the airbag is not
replaced, the unrepaired area will increase the risk of injury in a
collision.
Front passenger sensing system
The front passenger sensing system is designed to meet the regulatory
requirements of Federal Motor Vehicle Safety Standard (FMVSS) 208
and is designed to disable (will not inflate) the front passenger's frontal
airbag under certain conditions.
The front passenger sensing system works with sensors that are part of
the front passenger's seat and safety belt. The sensors are designed to
detect the presence of a properly seated occupant and determine if the
front passenger's frontal airbag should be enabled (may inflate) or
disabled (will not inflate).
The front passenger sensing system will disable (will not inflate) the
front passenger's frontal airbag if:
2006 Mariner (mrn)
Owners Guide (post-2002-fmt)
USA (fus)
Seating and Safety Restraints
107