Receiver 2, Local Port 2 And Alarm Port 2 Ip Address; Apn1 Username And Password, Apn2 Username And Password; Telephone Numbers To Decode; Dnis - DSC GS3125 Manual De Instrucciones

Receiver 2, Local Port 2 and Alarm Port 2 IP address

This check box is used to enter the second IP address for the receiver and the port number, with the difference that these
parameters are considered as a backup receiver. The Communicator only recognises this box if the parameters corresponding
to the Main Receiver, Local Port 1 and Alarm Port 1 address have been entered. Furthermore, the Enable Supervision
and Supervision time boxes refer only to the primary receiver.

APN1 Username and Password, APN2 Username and Password

Some providers may require a user name and password to validate communication. If needed, enter this information here.
APN2 Username and Password are considered to be backup data.

Telephone numbers to decode

This communicator permits to communicates the events in the Contact ID format, via the GPRS network, also to the control
panels that do not support this communication method.
To do this, you must setup a telephone number (the phone numbers can be "virtual" or "real") on the control panel for event
communication in Contact ID format (e.g. you can setup 0123), then you must enter the same telephone number in one of this
fields (you can program up to four telephone numbers for this function).
When the Communicator recognises a call from one of these numbers, automatically transcodes the event in digital format
and forwards it on the GPRS network to the set receiver (refer to the "Main Receiver" and "Backup Receiver" options).
     The telephone number must be of at least 2 digits.
The options "Prefix" and "Digits to Remove" have no effect on the "Telephone numbers to decode".
The "Telephone numbers to decode" must exactly match with the telephone numbers set for the control panel.
Leave this fields empty if you don't use this function.
For this feature to work correctly, the "Main Receiver" (and, where necessary the "Backup Receiver") option
must be selected.

DNIS

If required, enter the Dialled Number Identification Service number.

Account code

The account code for communication with SYSTEM III or SYSTEM II receivers must be entered in this box.

Enable Supervision

To enable supervision, select this option. The supervision option is ONLY available to the main receiver. The supervision
messages are not sent when the device is performing a voice call (on GSM).

Supervision time (sec)

Set the Supervision time for the monitored zones. It is possible to set a Supervision time between a minimum of 5 second
and a maximum of 65535 seconds, with steps of 1 second.

Remote programming (GS3125 series only)

This interface makes it possible to use the functionalities of the GS3100 Series Console software via a network. The transmitter
parameters can be managed remotely using this interface. To use this function, visit the web address http://www.dscreachme.com.
 Enabled: To enable the Remote Programming, click this check box to enter a tick      (this setting is enable by default).
 Encryption key: The encryption key can be set so that the Remote Programming cannot be accessed by unauthorised
persons. The encryption key may include between 1 and 32 hexadecimal characters. The default setting is 0
(encryption key not enabled).

Status

This page will allow you to monitor and control in real-time all the Communicator functions.
     ATTENTION: This page is updated every 5 seconds.

Status section

This section lists the most important data relating to the GSM module. The virtual display shows, in addition to the name of
the GSM network manager, the GSM signal strength (this is displayed through a special indicator).
GS3125/GS3105
G G G
G G
69