Connecting The Pdu - Tripp-Lite PDUMN15/NET Manual Del Propietário

Ocultar thumbs Ver también para PDUMN15/NET:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

Connecting the PDU

2-1
(Models with IEC power inlet or
3-pole IEC 309 plug only) Select
models have a detachable power cord.
Attach the included power cord to the
PDU by inserting the IEC connector
of the power cord into the IEC power
inlet
B
located near the end of the
PDU. Use the included bracket
secure the power cord connection.
Note: Optionally, a user-supplied power cord
can be attached to the PDU by connecting it
to the IEC inlet. Do not attempt to attach a
user-supplied power cord unless it is certified
to be compatible with the input power source
that will be used by the PDU.
2-2
(Optional - models with input plug
adapter only) Select models include
an input plug adapter that converts the
twist-lock input plug to a straight-blade
input plug. Attach the input plug
adapter
A
to the input plug
wish to plug the PDU into a compatible
straight-blade outlet.
2-3
Connect the input plug to a compatible
AC power outlet. If the PDU does not
have a circuit breaker, it should be
provided with a branch-rated over-
current protection device that matches
the rated amperage of the PDU.
Note: The AC power source should not share
a circuit with a heavy electrical load.
2-4
(Optional) If you attached the cord
retention bracket(s), tie each
equipment power cord to the retention
bracket. Attach each cord to the
retention shelf by looping the cord and
securing it with one of the included
cable ties
. Make sure each cord can
A
be unplugged from the PDU without
removing the cable tie.
16-10-209-933666.indb 4
A
A
C
to
2-1
B
if you
2-2
2-3
2-4
4
C
B
B
A
12/22/2016 11:31:34 AM
A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pdumnv20/netPdumnv30/netAg-0008Ag-0009Ag-0010

Tabla de contenido