Standard Installation - KENMORE ELITE SENSOR SMART 110.70092991 Manual Del Propietario E Instrucciones De Instalación

A. SELECT LOCATION FOR
YOUR DRYER
Selecting the proper location for your
dryer makes installation easy and gives
you the best drying performance.

STANDARD INSTALLATION

Check location where dryer will be installed.
Proper installation is your responsibility.
Make sure you have everything necessary
for correct installation (see illustration
below).
The dryer must not be installed where it can
be exposed to water and/or weather.
• Proper operation of dryer cycles
requires temperatures above 45°F (at
lower temperatures, the dryer may not
shut off at the end of automatic cycles and
drying times will be extended).
• Use at least the minimum installation
spacings described on page 12. This will
ensure you have an adequate clearance
for service and proper operation including
flow of combustion and ventilation air, and
that you have a sufficient distance from
combustible construction.
Grounded receptacle:
Within 2 ft of either
side of dryer.
Support: Floor must be sturdy
enough to support a total weight
of 175 lbs (includes dryer and
load weight).
10
WARNING
Explosion Hazard
Keep flammable materials and vapors,
such as gasoline, away from dryer.
Place dryer at least 18 inches
(46 cm) above the floor for a garage
installation.
Failure to do so can result in death,
explosion, or fire.
• Be sure your location allows for a
proper exhaust installation. A gas dryer
must be exhausted to the outdoors.
See pages 18-22 for complete exhaust
requirements.
• Check code requirements. Some
codes limit or do not permit installation
of clothes dryers in garages, closets,
mobile homes, or sleeping quarters.
Contact your local building inspector.
6 ft
6 Ft.Max.
Level floor: Maximum
allowable slope under
entire dryer – 1 in.
Rigid gas supply line:
Approved for natural
gas use.
Shut-off valve:
No further than
6 ft away from
dryer.