Basic Operation - THOMSON TT450BT Modo De Empleo

• After you finish playing a record, always put it back into its sleeve for storage. Leaving a record
unprotected could result in warping or scratching.
• Do not use cracked records.

Basic operation

Playing records
• Press the STANDBY/ON button on the back of the unit to turn it on.
• Open the turntable cover slowly.
OPEN
• Place a record on the turntable. When playing a 45 RPM large-hole single record, use the adapter
included.
• Set according to the rotation speed (RPM) of the record. The rotation speed can be set to 33 or
45 RPM.
• Turn the START/STOP rotation knob to START the turntable.
• When the START/STOP rotation knob is set to START, the turntable will start rotating and the blue
LED will light up.
• Move the tone arm clasp to the right to release the tone arm.
• Lift the cue lever.
• You can also leave the cue lever down and move the raised tone arm over the record and then lower
the tone arm slowly to start playback.
• Move the tone arm to the edge of the record or the track where you want to start playback.
• Lower the cue lever.
• Lower the tone arm slowly until the stylus touches the record and playback begins. We recommend
that you close the turntable cover during record playback to avoid dust.
• Do not place anything on the turntable cover. Objects on the cover might cause noise due to
vibrations or fall off, especially during playback.
Caution
• During playback, do not touch the tone arm or the rotating record.
• Do not stop turntable rotation during playback.
ON
STANDBY
- EN 8 -