Tripp-Lite SmartPro SMART500RT1U Manual Del Propietário página 4

Mounting (Rack)
2-Post (Telecom) Mounting
Mount 1U UPS models in 2-post racks with included hardware following the procedure below.
If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post
Rackmount Installation Kit (model: 2POSTRMKIT, sold separately). See Installation Kit owner's
manual for installation procedure for 2U UPS models.
Attach mounting ears
1
your equipment using the screws provided . The ears
B
should face backward.
Using an assistant if necessary, lift your equipment
2
and slide it onto the mounting shelves. Attach your
equipment to the rack by passing the screws, nuts and
washers provided
D
into the rack rails.
Mounting (Tower)
Mount all UPS models in an upright, tower position using included hardware. The user must deter-
mine the fitness of hardware and procedures before mounting.
All UPS Models
Stand your UPS on its side with the LED/Control panel at
the top. Attach one rack mounting ear
UPS using included screws
ears to the floor with user-supplied hardware.
2U UPS Models Only
Rotate the LED/Control panel to view it easier while the
UPS is tower mounted. Insert a small screwdriver, or other
tool, in the slots on either side of the panel. Pop the panel
out; rotate it; and pop the panel back in place.
continued
to the front mounting holes of
A
C
through its mounting ears and
to each side of the
A
. Attach the rack mounting
B
4
B
C
A
1
D
2
B
A