Kenmore 137.23671310 Manual De Uso Y Cuidado página 28

Troubleshooting (continued)
ELECTRONIC IGNITION:
" No spark,no ignitionnoise.
" No spark,someignition noise.
" Sparks,but not at electrode or at full
strength.
Burner(s) will not light
using igniter.
(See Electronic
Ignition
Troubleshooting also)
Burner(s) will not
match light.
Sudden drop in gas
flow or low flame.
Flames blow out.
Flare-up.
Persistent grease fire.
Flashback...
(fire in burner tube(s)).
Unable to fill LP
cylinder.
One burner does
not light from
other burner(s).
" See "GAS ISSUES:" on previous
page.
" Match will not reach.
" Improper method of match-lighting.
" Out of gas.
" Excess flow valve tripped.
" Vapor lock at coupling nut!LP
cylinder connection.
" High or gustingwinds.
" Low on LPgas.
" Excessflow valve tripped.
" Grease buildup.
" Excessive fat in meat.
" Excessive cooking temperature.
" Grease trapped by food buildup
around burner system.
" Burner and!or burner tubes are
blocked.
" Somedealers have older fill nozzles
with worn threads.
" Grease buildupor food particles in
end(s) of carryover tube(s).
" See Section I of Electronic Ignition System.
" See Section II of Electronic Ignition System.
" See Section III of Electronic Ignition System.
" Use long-stemmatch (fireplace match).
" See "Match-Lighting"sectionof Useand Care.
" Check for gas in LPcylinder.
"Turn off knobs, wait 30 seconds and light grill. If flames are
still low, turn off knobs and LPcylinder valve. Disconnect
regulator. Reconnect regulator and leak-test. Turn on LP
cylinder valve, wait 30 seconds and then light grill.
"Turn off knobs and LPcylinder valve. Disconnect coupling nut
from cylinder. Reconnect and retry.
" Turn front of grill to face wind or increase flame height.
" Refill LPcylinder.
" Refer to "Sudden drop in gas flow" above.
" Clean burners and inside of grill!firebox.
" Trim fat from meat before grilling.
" Adjust (lower) temperature accordingly.
"Turn knobsto OFF.Turngas off at LP cylinder. Leavelid in
positionand let fire burn out. After grill cools,remove and
clean all parts.
" Turnknobsto OFF.Clean burnerand!or burnertubes.See
burnercleaning sectionof Useand Care.
" The worn nozzles don't have enough "bite" to engage the
" Clean carry-over tube(s) with wire brush.
28 • 23671-46477279