For Your Safety - Kenmore 137.23671310 Manual De Uso Y Cuidado

Ocultar thumbs Ver también para 137.23671310:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LP Tank Exchange
• Many retailers that sell grills offer you the option of replacing
your empty LPtank through an exchange service. Use only
those reputable exchange companies that inspect, precision fill,
test and certify their cylinders. Exchange your tank only for
an OPD safety feature-equipped
tank as described in the
"LP Tank" section of this manual.
Always keep new and exchanged LPtanks in upright position
during use, transit or storage.
Leak test new and exchanged
LP tanks BEFORE
connecting to grill.
Connecting
Regulator
To The LP Tank
1. LPtank must be properly secured onto grill. (Refer to assembly
section.)
2. Turn all control knobs to the OFF position.
3. Turn LPtank OFF by turning OPD hand wheel clockwise to a full
stop.
4. Remove the protective cap from LPtank valve. Always use cap
and strap supplied with valve.
LP Tank Leak Test
For your safety
Leak test must be repeated each time LPtank is exchanged
refilled.
Do not smoke during leak test.
Do not use an open flame to check for gas leaks.
Grill must be leak tested outdoors in a well-ventilated area,
away from ignition sources such as gas fired or electrical
appliances. During leak test, keep grill away from open flan
or sparks.
Use a clean paintbrush and a 50/50 mild soap and water
solution. Brush soapy solution onto areas indicated by arrows in
figure below. Leaksare indicated by growing bubbles.
If "growing"
bubbles appear do not use or move the LP
tank. Contact
an LP gas supplier or your fire department!
A Do not use household cleaning agents. Damage to the gas
train components (valve/hose/regulator)
can result.
Safety Relief Valw
OPD Hand Wheel
Type 1 outlet with
thread on outside
/
Strap and Cap
Do not insert a POL transport
plug (plastic part with external
threads) into the type 1 valve
outlet. It will defeat the Safety
Relief Valve feature.
5. Hold regulator and insert nipple into LP
tank valve. Hand-tighten the coupling
nut, holding regulator in a straight line
with LPtank valve so as not to crossth-
thread the connection.
Nipple has to be
centered into the
LP tank valve.
23671-46477279
_ 5

Publicidad

Tabla de contenido
loading

Tabla de contenido