Tripp-Lite SmartPro SMART1500CRMXL Manual Del Propietário página 12

Basic Operation
"BATTERY WARNING" LED: this LED lights red and an alarm sounds
intermittently after you initiate a self test (See "MUTE/TEST" Button
description) to indicate the UPS batteries need to be recharged or
replaced. Allow the UPS to recharge continuously for 12 hours, and repeat
the self-test. If the LED continues to light, contact Tripp Lite for service. If
your UPS requires battery replacement, visit www.tripplite.com to locate
the specific Tripp Lite replacement battery for your UPS.
Other UPS Features (Rear Panel)
AC Bypass Alarm Switch (Select Models): If the UPS system
experiences a processor fault or if the internal battery is completely
depleted, the AC bypass will pass through AC power to connected
equipment and the audible AC bypass alarm will sound continuously. If
you need to silence the AC bypass alarm, move the "AC Bypass Alarm"
switch to the "Disable" position. Contact Tripp Lite for assistance at
(773) 869-1234.
15A 120V
NEMA 5-15R
20A 120V
NEMA 5-20R NEMA L5-30R
Communications Ports (USB or RS-232): These ports connect your
UPS to any workstation or server. Use with Tripp Lite's PowerAlert Software
and included cables to enable your computer to automatically save open
files and shut down equipment during a blackout. Also use PowerAlert
Software to monitor a wide variety of AC line power and UPS operating
conditions. Consult your PowerAlert Software manual or contact Tripp Lite
Customer Support for more information. See "USB and RS-232 Serial
Communications" in the "Optional Installation" section for installation
instructions.
EPO (Emergency Power Off) Port: Your UPS features a EPO port that
may be used to connect the UPS to a contact closure switch to enable
emergency inverter shutdown. See Optional Installation.
14-12-044-932757.indb 12
continued
AC Outlets: All models include NEMA 5-15R and/or
NEMA 5-20R outlets. Select models also include NEMA
L5-20R or NEMA L5-30R outlets. These outlets provide
your connected equipment with AC line power during
normal operation and battery power during blackouts and
brownouts. The UPS protects equipment connected to
20A 120V
these outlets against damaging surges and line noise. If
NEMA L5-20R
you have a serial or USB connection to your UPS, you can
remotely reboot connected equipment by turning the
outlets OFF and ON using Tripp Lite's PowerAlert Software.
The outlets are divided into one or more load banks
(labelled "LOAD 1," etc.) which may be remotely switched
OFF and ON without interrupting power to equipment
connected to the other outlets. Outlets labelled
30A 120V
"UNSWITCHED" may not be remotely switched off.
12
12/16/2014 5:11:07 PM