Optional Installation - Tripp-Lite SmartPro SMART1500CRMXL Manual Del Propietário

Quick Installation
4
Plug your equipment into the UPS.*
* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total VA
ratings for all the equipment you connect exceeds the
UPS's Output Capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is
listed in amps, multiply the number of amps by 120
to determine VA. (Example: 1 amp × 120 = 120 VA).
If you are unsure if you have overloaded the UPS's
outlets, see "OUTPUT LOAD LEVEL " LED description.
5
Turn the UPS ON.
Press and hold the "ON/OFF/STANDBY" button
for one second. The alarm will beep once
A
briefly after one second has passed. Release
the button.
Note: UPS system will function properly upon initial
startup; however, maximum runtime for the unit's battery
will only be accessible after it has been charged for 24
hours.

Optional Installation

These connections are optional. Your UPS will function properly without these
connections.
1 USB and RS-232 Serial
Communications
Use the included USB cable (see
DB9 serial cable (see
communication port on your computer to the
communication port of your UPS. Install on your
computer the Tripp Lite PowerAlert Software
appropriate to your computer's operating
system.
14-12-044-932757.indb 8
continued
) or
1a
) to connect the
1b
8
4
A
5
1a
1b
12/16/2014 5:11:05 PM