Surface-Mounted Cabinet Installation - Bradley EFX 25 Instrucciones Para La Instalacion Y Mantenimiento

Válvula mezcladora termostática con armario opcional
Ocultar thumbs Ver también para EFX 25:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation and Maintenance Instructions
Installation Instructions: Valve with Optional Surface-Mounted Cabinet
Note: Flush the supply lines before beginning installation.
1. Measure and mark the cabinet mounting hole locations at the dimensions shown in Figure 4. Install six
3/8" wall anchors (supplied by installer).
2. Position the cabinet onto the wall and secure into place with six 3/8" wall fasteners (supplied by
installer).
3. Install the valve nipples and one-half of the union ball valve using pipe dope or teflon tape. Then install
the other half of the union ball valve onto the inlet and outlet piping.
4. Insert the valve into the bracket in the cabinet (right side of the valve goes in first). Continue with the
valve installation procedure found on page 3.
Figure 4
Bradley Corporation • 215-1290 Rev. L; EN 10-09-001
Bradley EFX 25 Thermostatic Mixing Valve with Optional Cabinet
FRONT VIEW
BOTTOM VIEW
Model S19-2100 Series
SIDE VIEW
MOUNTING HOLE LOCATIONS
4/13/10
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

S19-2100

Tabla de contenido