Surface-Mounted Cabinet Installation - Bradley S19-2200 Serie Instrucciones Para La Instalacion Y Mantenimiento

Installation and Maintenance Instructions
Installation Instructions: Valve with Optional Surface-Mounted Cabinet
Note: Flush the supply lines before beginning installation.
1. Measure and mark the cabinet mounting hole locations at the dimensions shown in Figure 4. Install six
3/8" wall anchors (supplied by installer).
2. Position the cabinet onto the wall and secure into place with six 3/8" wall fasteners (supplied by
installer).
3. Install the valve nipples and one-half of the union ball valve using pipe dope or teflon tape. Then install
the other half of the union ball valve onto the inlet and outlet piping.
4. Insert the valve into the bracket in the cabinet (right side of the valve goes in first). Continue with the
valve installation procedure found on page 3.
FRONT VIEW
Figure 4
Bradley Corporation • 215-1289 Rev. H; EN 06-909
Bradley EFX 60 Thermostatic Mixing Valve with Optional Cabinet
BOTTOM VIEW
Model S19-2200 Series
SIDE VIEW
(64mm)
(64mm)
MOUNTING HOLE LOCATIONS
1/29/07
(57mm)
5