Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Toyota Corolla 2003-2008
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) ISO DDIN trim plate • B) ISO DDIN brackets
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1761 • TYTO-01
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 10mm Socket wrench
METRA. The World's best kits.
Installation instructions for part 95-8204
95-8204
metraonline.com
™
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DDIN radio provision ...................................... 3
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Tabla de contenido
Manuales relacionados para Metra 95-8204
Resumen de contenidos para Metra 95-8204
- Página 1 KIT COMPONENTS • A) ISO DDIN trim plate • B) ISO DDIN brackets CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING & ANTENNA CONNECTIONS (sold separately) Dealership for more information.
-
Página 2: Dash Disassembly
95-8204 Dash Disassembly 1. Unclip and remove the gear shifter trim panel. (Figure A) PASSENGER 2. Remove the center climate control knob, and (1) Phillips screw exposed behind it. (Figure B) 3. Unclip and remove the climate- control/pocket assembly. (Figure C) 4. -
Página 3: Kit Assembly
Metra recommends using the proper mating adapters from Metra and/ (Figure B) (Figure A) or AXXESS. Reconnect the negative battery terminal and test the radio for proper operation. -
Página 4: Important
Installation instructions for part 95-8204 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. -
Página 5: Características Del Kit
Instrucciones de instalación para la pieza 95-8204 Indice Toyota Corolla 2003-2008 95-8204 Desmontaje del tablero ......... 2 Ensamble del kit – Provisión de radio ISO DDIN ......... 3 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DDIN COMPONENTES DEL KIT •... -
Página 6: Desmontaje Del Tablero
95-8204 Desmontaje del tablero 1. Suelte y retire el panel de ajuste palanca de cambios. (Figura A) PASSENGER 2. Retire la perilla de centro de control climático, y (1) tornillo Phillips expuestos detrás de él. (Figura B) 3. Suelte y retire el conjunto de climatización/bolsillo. -
Página 7: Ensamble Del Kit
Metra recomienda que use adaptadores adecuados de (Figura B) (Figura A) acoplamiento de Metra y/o de AXXESS. Vuelva a conectar la terminal negativa de la batería y pruebe el radio para verificar que funcione correctamente 4. Vuelva a armar el tablero al revés... -
Página 8: Importante
Instrucciones de instalación para la pieza 95-8204 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...