Metra 95-8211 Instrucciones De Instalación

Toyota avalon 2000-2004

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Toyota Avalon 2000-2004
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) ISO DDIN trim plate
A
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1761 • TYTO-01
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 10mm socket wrench
METRA. The World's best kits.
Installation instructions for part 95-8211
95-8211
metraonline.com
Table of Contents
Dash Disassembly
– Column shift models ............................................ 2
– Console shift models ............................................ 3
Kit Assembly
– ISO DDIN radio provision ...................................... 4
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Metra 95-8211

  • Página 1 KIT COMPONENTS • A) ISO DDIN trim plate CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING & ANTENNA CONNECTIONS (sold separately) Dealership for more information.
  • Página 2: Dash Disassembly

    95-8211 Dash Disassembly Column shift models 1. Unclip and remove the trim panel below the climate controls. Remove (2) 10mm screws now exposed. (Figure A) 2. Carefully pull the air vents above the radio towards the rear of car to unclip and remove them.
  • Página 3 95-8211 Dash Disassembly Console shift models 1. Open the center console armrest, unclip the cover above the cup holder, and then remove (2) Phillips screws toward the outside of the panel. (Figure A) 2. Lift up and remove the shifter trim/ashtray assembly. (Figure B) 3.
  • Página 4: Kit Assembly

    (Figure A) climate controls. Metra recommends using the proper mating adapter from Metra or AXXESS. NOWLEDGE IS OWER Enhance your installation and fabrication skills by Reconnect the negative battery terminal and enrolling in the most recognized and respected test the radio for proper operation.
  • Página 5: Características Del Kit

    Instrucciones de instalación para la pieza 95-8211 Indice Toyota Avalon 2000-2004 95-8211 Desmontaje del tablero – Modelos de cambio de la columna ....... 2 – Modelos de cambio de la consola ......3 Ensamble del kit CARACTERÍSTICAS DEL KIT – Provisión de radio ISO DDIN ......... 4 •...
  • Página 6: Desmontaje Del Tablero

    95-8211 Desmontaje del tablero Modelos de cambio de la columna 1. Desenganche y quite el panel de la moldura de debajo de los controles de clima. Quite los (2) tornillos de 10 mm que quedan expuestos. (Figura A) 2. Jale con cuidado las rejillas del aire de arriba del radio hacia la parte trasera del auto para desengancharlas y quitarlas.
  • Página 7 95-8211 Desmontaje del tablero Modelos de cambio de la consola 1. Abra el descanzabrasos de la consola central, desenganche la tapa de arriba del portavasos y luego quite los (2) tornillos Phillips que están hacia el exterior del panel. (Figura A) 2.
  • Página 8: Ensamble Del Kit

    Instrucciones de instalación para la pieza 95-8211 Ensamble del kit IMPORTANTE Si tiene dificultades con la instalación Provisión de radio ISO DDIN de este producto, llame a nuestra línea 1. Usando los tornillos suministrados con el radio, de soporte técnico al 1-800-253-TECH.

Tabla de contenido