Metra 95-8224 Instrucciones De Instalación

Toyota Matrix 2009-10 / Pontiac Vibe 2009-10
(Excluding Factory Navigation Models)
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) ISO DDIN trim plate • B) ISO DDIN brackets
A B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1761 (Matrix) • TYTO-01 (Matrix w/ amp) • 70-2105 (Vibe)
Antenna Adapter: • Not required (Matrix) • 40-CR10 (Vibe)
TOOLS REQUIRED
• Panel removal tool • 10mm socket wrench
METRA. The World's best kits.
Installation instructions for part 95-8224
95-8224
metraonline.com
™
Table of Contents
Dash Disassembly ..................................................2
Kit Preparation ........................................................2
Kit Assembly
– ISO DDIN radio provision ...................................... 3
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION