Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Honda Civic 2001-2005 (excluding Si)
KIT FEATURES
• DIN radio provision with pocket
• ISO DIN radio provision with pocket
KIT COMPONENTS
• A) Radio housing • B) ISO Trim plate • C) ISO brackets
A
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1721
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel Removal Tool • Phillips Screwdriver
METRA. The World's best kits.
Installation instructions for part 99-7899
99-7899
B
C
™
metraonline.com
Table of Contents
Dash Disassembly ..................................................2
Kit Preparation ........................................................3
Kit Assembly
– DIN radio provision with pocket ............................ 3
–
ISO DIN radio provision with pocket ...................... 4
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
Publicidad
Tabla de contenido
Manuales relacionados para Metra 99-7899
Resumen de contenidos para Metra 99-7899
- Página 1 KIT COMPONENTS • A) Radio housing • B) ISO Trim plate • C) ISO brackets CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING &...
-
Página 2: Dash Disassembly
99-7899 Dash Disassembly 1. Remove the power outlet panel: b. Unclip the shifter trim panel and then remove (2) Phillips screws For all 2001-2002 models, and all located between the shifter and DX and HX trims: the cupholder. (Figure C) a. -
Página 3: Kit Preparation
4. Reinstall the climate control pod necessary connections to the back to the climate/radio bezel in radio and climate controls. Metra reverse order of disassembly. recommends using the proper mating adapter from Metra and/or 5. -
Página 4: Important
Installation instructions for part 99-7899 Kit Assembly IMPORTANT ISO DIN radio provision with pocket If you are having difficulties with the 1. Remove the metal DIN sleeve and trim ring installation of this product, please call our from the aftermarket radio. -
Página 5: Características Del Kit
Instrucciones de instalación para la pieza 99-7899 Indice Honda Civic 2001-2005 (a excepción de Si) 99-7899 Desmontaje del tablero ..........2 Preparación del kit ..........3 Ensamble del kit – Provisión de radio DIN con cavidad ...... 3 CARACTERÍSTICAS DEL KIT –... -
Página 6: Desmontaje Del Tablero
99-7899 Desmontaje del tablero 1. Quite el panel de tomacorriente: Desenganche el panel de la moldura de la palanca de velocidades y Para todos los modelos 2001-2002 y luego quite los (2) tornillos Phillips todas las molduras DX y HX: localizados entre la palanca de velocidades y el portavasos. -
Página 7: Preparación Del Kit
4. Vuelva a instalar el alojamiento conexiones necesarias al radio del control del clima en el bisel y los controles del clima. Metra del clima/radio en orden inverso a recomienda que use adaptadores como lo desarmó. -
Página 8: Importante
Metra recomienda que problemas antes de llamar. use adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. Vuelva a conectar la EL CONOCIMIENTO ES PODER terminal negativa de la batería y pruebe el radio Mejore sus habilidades de instalación y...