Important - Metra 99-7899 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim ring
from the aftermarket radio.
2. Secure the ISO brackets to the radio using
the screws supplied with the radio. (Figure A)
3. Slide the radio into the radio housing until it
clicks in.
4. Locate the factory wiring harness and antenna
connector in the dash, and complete all
necessary connections to the radio and climate
controls. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Re-connect the negative battery terminal and
test the radio for proper operation.
5. Snap the ISO trim plate onto the radio
housing, and then reassemble the dash in
reverse order of disassembly. (Figure B)
METRA. The World's best kits.
Installation instructions for part 99-7899
Kit Assembly
(Figure A)
(Figure B)
™ metraonline.com

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER