Dash Disassembly; Kit Preparation - Metra 95-7424 Instrucciones De Instalación

1. Unclip the entire dash panel including the
radio and climate controls. Unplug and
remove the panel. (Figure A)
2. Remove (4) Phillips screws securing the
radio chassis. Unplug and remove the
chassis. (Figure B)
3. Remove (4) T-10 Torx screws securing
the climate controls to the dash panel and
remove the controls from the panel (retain
the screws and climate controls for re-use
during kit preparation). (Figure C)
4. Remove (2) T10 Torx screws securing the
passenger air bag status light assembly to
the dash panel and remove the light from
the panel (retain the screws and light for
re-use during kit preparation). (Figure C)
Note: The small round Airbag sticker also
needs to be removed from the factory panel
and placed onto the 95-7424 radio housing
panel (a round piece of double-sided tape
is provided in case the factory sticker is not
strong enough). (Figure C)
Continue to kit preparation

Dash Disassembly

(Figure A)
A/C Control Panel
(Figure C)
95-7424
(Figure B)
Passenger air bag light
T-10 Torx T-10 Torx
screw screw
2

Kit Preparation

1. Attach the climate controls to the
Trim Panel using the factory hardware
removed during the dash disassembly.
(Figure A)
2. Attach the passenger air bag status
light assembly to the Trim Panel using
the factory hardware removed during
the dash disassembly. (Figure B)
Also, apply to air bag button the
small round airbag sticker previously
removed in dash disassembly.
(Figure B)
Continue to kit assembly