No-Cycle Timer Datalogging - RS Pro RS-1151 Manual De Instrucciones

Datalogger Sound Level Meter / EN

8-5 No-Cycle Timer Datalogging

The no-cycle timer means the Start-Time and the Stop-Time is valid only
one time.
1. Perform setting the Real-Time. (Refer to 8-1)
2. Press and hold down TIME key then press
the "
3. Press ▲ key 2 times to select this mode, the "
4. Press ↵ key to enter the Start-Time setting mode, the "►
mark is displayed.
5. Using ► key to position the cursor on the date or time element to adjust.
Using ▲ key to change the setting the date or time element value.
6. Press ↵ key to enter the Stop-Time setting mode, the "
is displayed.
7. Repeat step 5 to complete the Stop-Time setting.
8. Press ↵ key to enter the Interval-Time setting mode, the "
mark is displayed.
9. Using ► key to position the cursor on the minute or second element to
adjust.
10. Using ▲ key to setting the desired interval time from 1 second to 59
minutes 59 seconds.
11. Press ↵ key to complete the action and to enter the no-cycle timer
datalogging mode, the "►" mark is a flashing display.
12. When the Start-Time is reached, the "►" mark stops flashing and the "A"
mark is displayed. When the "M" mark appears once it means one set of
data has been memorized.
13. If no SD CARD is in the meter, the "
14. When the Stop-Time is reached, the "A" mark will disappear and the " "
mark is displayed.
15. If memory is full, the "
4GB or 99 blocks.
16. Press LOG key for 3 seconds to exit.
14
" mark is displayed.
" mark is displayed for 2 seconds.
" mark is displayed. The maximum capacity is
key to turn on the meter, until
" mark is displayed.
÷
÷
09/15/17 Version No. 00
"
Y÷M
" mark
Y÷M
: "
m:s