Bradley S19-270C Manual Del Usuario página 9

Installation
Installation
— Left-Hand Units (Halo)
Halo eyewash unit is shown. Halo eye/face wash unit is similar.
Apply pipe sealant (supplied by installer) to all male-threaded pipe joints.
Remove the set screw from
A
the valve assembly with an
Allen key (1/16"(1 .5mm)) and
set aside .
Mount the unit onto the deck . Refer to the instructions on page 6 for
F
eyewash units or page 7 for eye/face wash units .
The left-hand unit must be installed on the left side of the deck .
Bradley • 215-1326 Rev. V; ECN 15-05-042
Rotate the
B
arm 180°
around the
valve .
C
Loosen the cap assembly with
D
an Allen key (5/16"(8mm)) and
rotate the sprayhead 180° .
E
Tighten cap assembly,
ensuring head is level .
S19-270C, S19-270E, S19274C, S19274E
Using low strength thread locker,
reinstall the set screw into the valve
in the new location shown until it
bottoms out, then back off ½ turn .
Arm must swing freely .
Rotate the head and body 180°
around the arm .
Slowly open the water supply lines to
G
relieve air and pressurize the valve . Test
the unit for leaks and adequate flow .
10/5/2017 9