Precautions for installation
The installation should comply with local electrical code.
This product is designed to be used indoors.
This product is not operable outdoors.
Do not expose this product to direct sunlight for hours and do not install the product near a heater
or an air conditioner.
Otherwise, it may cause deformation, discoloration and malfunction. Keep this product away from
water.
Procure a tripod separately.
The tripod to mount the camera head is not supplied. Prepare it according to the area where the
camera is to be installed.
Avoid moist or dusty places to install this system.
Otherwise, lifetime of the internal parts may be shortened.
Avoid installing or using this system in the following locations:
•
Locations where it may get wet from rain or water splash
•
Locations where a chemical agent is used such as a swimming pool
•
Locations subject to humidity, dust, steam and oil smoke
•
Locations where a radiation, an X-ray, a strong radio wave or a strong magnetic field is gener-
ated
•
Locations where corrosive gas is produced
•
Locations where the temperature is not within 0 °C to 40 °C
•
Locations subject to vibrations (This product is not designed for on-vehicle use.)
•
Locations subject to condensation as the result of severe changes in temperature
Radio interference
Images may be distorted near a transmitting antenna for TV or radio broadcasting signals or electric
or magnetic fields (for example, caused by a motor and a transformer).
Be sure to remove this product if it is not in use.
15