Service And Maintenance - LGB 24266 Manual De Instrucciones

Programming by means of Pages (Universal-Handy 55015)
All CVs up to CV 1024 can be changed with programming by means of pages. The
process can be compared to programming by means of CVs, but it uses the CVs 1 to 4
in place of CV 5 for the value. Pages are areas in which 4 addresses can be summa-
rized. CVs 1 to 4 correspond then to the 4 addresses that are summarized on the page.
The numbers to be entered can be generated with the following equations:
(CV - 1 ) / 4 = Page Whole number result is Page
(decimal x 4) + 1 = Data CV
If for example CV 322 is to be programmed at 200, the following calculation will result:
(322 -1) / 4 = 80,25 Page 80; CV6 = 80
0,25 x 4 + 1 = 2
In order to program that the „page" 80 is first programmed in CV 6 and the value 200
is immediately programmed in CV 2.
Value in CV 2
Maintenance
Lubrication
Oil the axle bearings and the side rod bearings now and then with a drop of Märklin
oil (item no. 7149).
Replacing Light Bulbs (E130023)
Lamps (front, above in the rear): Pull the lamp housing from the model. Pull the light
bulb from the socket. Insert the new light bulb. Put the model back together.
Lamps (lower rear): Remove the ring on the outside of the lamp glass. Carefully lift
the glass from the lantern. Pull the light bulb from the socket with a pair of tweezers.
Insert the new light bulb. Put the model back together.
Interior Lighting: Pull the light bulb from the socket with a pair of tweezers. Insert the
new light bulb.
Replacing Traction Tires (E126174)
- Remove the valve gear hanger between the first and second axle.
- Loosen the hex head screws used to mount the drive rods and side rods to the
third axle.
- There are several screws on the underside of the drive gear: Remove the second
and fifth screws from the front.
- Pull the drive gear out of the frame. Detach the wire.
- Use a small flat blade screwdriver to change the traction tire:
- Lift the old traction tire from the groove in the driving wheel.
- Carefully push the new traction tire into the groove.
- Make sure that the traction tire is properly seated.
- Put the model back together.
Replacing the Smoke Unit
- Pull the cover from the smoke stack (Fig. 5).
- Remove the damaged smoke unit (smoke stack insert) from the smoke stack with
needle nose pliers or a pair of tweezers (Fig. 6).
- Cut the wires.
- Connect the wires to the new smoke unit. When doing this twist the ends of the
wire that have had insulation stripped from them and insulate them from contact
with other wires (Fig. 7).
- Push the new smoke unit into the smoke stack.
- Put the model back together.
13