Service And Maintenance; Controllable Functions - LGB 20782 Manual Del Usuario

SERVICE
Lubrication
The axle bearings and the side rod bearings should be lubricated occasionally with a
small amount of Märklin-Oil (7149).
Replacing the light bulbs (E130 023)
Remove the ring on the outside of the lamp glass. Carefully lift the glass from the
lantern. Pull the light bulb from the socket with a pair of tweezers. Insert the new light
bulb. Put the model back together.
Replacing the traction tire (E126 174)
• Loosen the hex head screw on the rear drive wheel with a traction tire.
• Remove the side rods and drive rods.
• Use a small, straight-blade screwdriver to replace the traction tire: Pry the old
traction tire out of the wheel groove.
• Gently insert the new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the wheel groove.
Cleaning
Clean the locomotive only with a soft cloth. Do not use any cleaning agents or abra-
sive cleaners.

Controllable Functions

1
Lighting
Sound effect: Long whistle blast
Sound effect: Squealing brakes off
Sound effect: Bell
Sound: Greeting announcement
Sound effect: Coal being shoveled
Sound effect: Operating sounds
Smoke generator
Sound on/off
ABV, off
Engineer's cab lighting
Sound: Conductor's whistle and doors closing
Double A switching light
Sound effect: Short whistle blast
Sound effect: Blowing off steam
Sound effect: Injector
Sound effect: Announcement
Sound effect: Announcement
Sound: National hymn
1
active in analog operation
2
with random sounds
10
1, 2
LV + LR
1 Sound 1
2 BS
3 Sound 3
4 Sound 4
5 Sound 9
6 FS
7 AUX 1
8
9
10 AUX 6
11 Sound 13
12
13
14 Sound 2
15 Sound 14
16 Sound 12
17 Sound 5
18 Sound 6
19 Sound 15