Service And Maintenance - LGB ABe 4/4 RhB Manual

SERVICE
Lubrication
Oil each of the axle bearings now and then with a drop of Märklin oil (7149).
Changing Light Bulbs
Lamps (below): Carefully lift the glass from the lantern. Using a pair of tweezers, pull
the light bulb plugged into the socket out of the latter. Insert a new light bulb. Put the
model back together again.
Lamps (above): Remove the lamp housing from the model. Pull the light bulb plugged
into the socket out of the latter. Insert a new light bulb. Put the model back together
again.
Interior Lighting: This model must be disassembled extensively to replace the light
bulbs. We therefore recommend having these light bulbs replaced by an authorized
repair station.
Changing Traction Tires
Remove the old traction tire with a small flat blade screwdriver: Lift the old traction
tire out of the groove in the driving wheel. Carefully push the new traction tire over
the wheel and insert it into the groove of the wheel. Check to make sure that the
traction tire is properly seated.
All manuals and user guides at all-guides.com
Function Mapping DCC
It is possible to assign functions controlled from the decoder to function buttons
of your choice (mapping). To do this an appropriate value must be entered in the
appropriate CV.
The CVs (lines) and the functions (columns) are listed in the tables on pages 42/43.
Four CVs belong to each button. For space reasons the 4 CVs were put together in
one line starting with CV 282 (Button F5).
It is basically possible to assign several functions to one button or one function to
several buttons.
Note: The programming for function mapping should be done only by experienced
users.
Individual functions can be controlled by means of SUSI depending on the design of
the decoder. These functions can be handled by the decoder as sound. The volume
levels belonging to these functions cannot be changed.
Examples of Function Mapping:
AUX 2 is to be forwards and backwards on Function 3
CV 272 & CV 372 = 8
CV 273 & CV 373 = 0
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
Sound 15 is to be shifted from forwards and backwards on Function 3 to Function 8.
The existing function at Function 8 is overwritten in the process.
CV 275 & CV 375 = 0
CV 273 & CV 373 = 0
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
CV 297 & CV 397 = 0
CV 298 & CV 398 = 0
CV 299 & CV 399 = 0
CV 300 & CV 400 = 4
12
away from Function 3
to Function 8