Using A Lap Belt Only - GB IDAN Manual Del Usario

InStallInG the baSe USInG a lap belt only
BefoRe installing base, make sure vehicle is on
level ground. place base on an approved vehicle
seating location.
1
Unfold the load leg from underneath the Base.
2
position Base on a rear vehicle seat. if a hump is
present on the floor of the vehicle, see page 34
for important information on the limits of using
the load leg in this seating position.
3
adjust the leveling foot to achieve the correct
angle for your child's weight as shown on the
level indicator. see page 37.
4
fully open Belt tensioning plate by turning the
orange locking lever to the
and lifting up on the plate.
once open, the Belt tensioning plate will remain
open on its own. the locking lever should be in
the open position with the plate open.
46
3
open position
2
1
4