GB IDAN Manual Del Usario página 52

InStallInG Infant CarrIer wIthoUt the baSe USInG only
neveR install this child restraint using a
non-locking vehicle lap shoulder belt. ( see page 27-29)
a locking clip must be used with a vehicle belt that does
not loCK. call the gB Customer service department
at 1.844.543.2020 to obtain a locking clip.
place child in the carrier.
1
position the infant carrier on a rear vehicle seat, with the
handle in position a ( see page 20), with the foot end
towards the vehicle seat back, push it firmly against the
vehicle seat.
2
Route the lap belt portion of the seat belt
into the belt guides on the caRRieR.
make sure the belt is correctly routed on
both sides and buckle the belt.
3
WaRning! the vehicle belt buckle must
under no circumstances reach the lower lap
belt guide. if the belt stalk is too long, the
infant car seat is not suitable for use
in this position in the
vehicle. in case of
doubt, please contact
the manufacturer of
your vehicle.
52
a lap/ShoUlder belt
3
1
2
Position a
CLICK!