BEARWARE 302363 Manual De Usuario página 15

4 Commissioning
Remove the product from the packing and remove the plastic strip, which is
protruding out of the battery compartment on the back side of the energy cost
meter.
Then connect the electrical devices, whose energy consumption has to be
recorded, to the meter. Then plug the energy cost meter into a properly installed
shockproof socket.
The device is now ready to be used. Detailed information on the operation and
the setting options are given in the following sections of this user manual.
5 Commissioning
Before using the device for the first time, reset it to the factory settings. Take an
object with a suitable tip (e.g. pen) and introduce it into the "RESET" opening on
the front side of the device to reset all data and programs.
6 "UP" and "SET" buttons
The current time, price as well as the electricity tariff can be set using the "UP"
and "SET" buttons. Either the 12 or 24 hour display can be selected.
7 "FUNC" button
The "FUNC" button can be used to change between the different display types.
The following list shows the setting options:
1. Time display, 2. Voltage display, 3. Mains current display, 4. Power supply
capacity display, 5. Display and storage of the total energy used, 6. Display and
storage of the total electrical load over a period, 7. Display and storage of the
total electrical load as per tariff 1, 8. Display and storage of the total electrical
load as per tariff 2, 9. Display of power frequency, 10. Display of "Powerfactor",
11. Adjustable price per kWh
15
English